Method for Installing Tempered Glass

The variety of sheet glass materials, superior performance and good quality, not only can be used as a decoration, but also has a wide range of durable functions. Glass partitions, car window glass, glass sheet must be the home. Smooth, flat, pure and bright, it is necessary in all walks of life. We will introduce the installation and fixing methods of tempered glass in the following, and hope to be helpful.

The installation method

1.Measuring the pay-off line

According to the design drawing size, measure the pay-off line, measure the elevation of the base level, the central axis of the glass wall and the upper and lower parts, and close the position line of the U-shaped 3*3, 3*4 steel trough.

2.Installation of the upper glass groove on the lower side of the embedded iron piece

Installing the groove bottom steel part according to the size of the design drawing, fix it with expansion bolts, then installing the upper and side steel glass troughs. Straighten and straighten, then fix. Install the groove Underlay tape, all non-stainless steel parts are painted with anti-rust paint.

3.glass block installation and positioning

10mm tempered flat glass are all custom-made in professional manufacturers, transported to the construction site. First clean the glass tank and glass block, using glass mounting machine or shipping suction cup to place the glass block in the installation slot, leveling, After vertical, it is fixed by plastic block. The same glass wall is installed and leveled, and the glue is started vertically.

4, Caulking rubber

After the tempered glass is fully seated, the flatness and verticality are corrected, and the polystyrene foam insert is embedded in the notch to make the tempered glass and the metal trough joint flat and tight, and then the silicone structural adhesive is applied.

5.Border decoration

Generally non-mullion glass partition wall frame is embedded in the wall, cylinder and floor finish layer, at this time as long as the fine processing of walls, cylinders and ground facing blocks and inlay or connect with the glass when installing.

6.Cleaning and finished product protection

After the mullion glass partition wall is installed, using cotton yarn and detergent to clean the glue traces and stains on the sheet glass surface, and then using the adhesive tape to make eye-catching signs to prevent collision. The accident of the sheet glass occurred.